Product Parameters:

1.LED chip: San’an SMD3528&2835  

2.Work Voltage:12V DC 

3.Beam angle: 180 Degree

4.Color: White/Red/Yellow  

5.Suitable Socket: Vehicle joint no need change anything.

6.Product Function: Brake Light. Turn Light. Running Lamp.

7.Size:   L49"*W0.55"*H0.26"  L60"*W0.55"*H0.26" L70"*W0.55"*H0.26"

Warning: The installation of this kit is recommended to be installed by a licensed professional .the improper installation of this kit will void all warranties.

Please read the following instructions thoroughly before installing it.

            First using a tape measure, measure the lip under your trucks tailgate to ensure there is enough clearance to mount your tailgate light bar.

            Following your trucks owner’s manual, carefully remove the tailgate from your truck.

            Use the included 3M tape to temporarily mount the LED light bar to your trucks tailgate.

            Using a 1/8thdrill bit, pre drill the four mounting holed into your trucks tailgate, this will make the following step much easier.

            Securely mount the tailgate light bar to your truck using a drill and provided screws.

            Run the power wire with flat 4pin connector behind your bumper and to your trucks flat 4pin connection. You may need to secure the slack in the wire so that it does not hang below the bumper.

If your purchased LED Tailgate light Bar with Reverse Light Option proceed with your installation using the flowing steps:

Carefully remove one of your tail light assemblies.

Power your truck on and pit it into reverse, So that your factory reverse lights are illuminated. It is imperative that you set the parking brake.

Return a volt meter, find the positive 12volt wire that powers your reverse light.

Using a volt meter , find the positive 12volt wire that powers your reverse light.

Once you have found your factory reverse light wire , use a wire stripper to cut and strip the wire.

Run the light bar’s whiter reverse wire to your factory reverse wire.

Use a butt connector to connect the tailgate bar’s white reverse wire to the trucks factory reverse wire. You can also solder or use a 3M tape connector to secure this connection.

Now you can re-install your tail light assembly and tailgate. And test your tailgate light bare to full functionality.

Please don’t connect it on the flasher of vehicle.

Flat 4 Pin Connector Diagram:

 

Red Wire: Running lamp, all White LEDs light up (5+1)

Green Wire: Left Turn Signal,left Yellow LEDs light up (5+2)

Yellow Wire: Right Turn Signal,right Yellow LEDs light up(5+3)

White Wire: Brake Lamp,all Red LEDs light up(5+4)

Gray Wire: Ground  ( 5 )

• ￥43.00
  汽車燈條 皮卡車燈帶 卡車專用 防撞條 剎車轉向LED燈條 推廣
• ￥55.00
  新款USB汽車氛圍燈條 兼容USB 汽車USB燈條 汽車音樂控?zé)魲l LED燈
• ￥53.00
  新款汽車音樂節奏控制氛圍燈條 汽車燈條 底盤汽車裝飾燈條推廣
• ￥28.00
  手持式便攜led日光 可充電磁鐵燈 探險燈 應急爆閃日光燈管 推廣